AMX Modero NXD-1200V, Operation/Reference Manual

Page: 31 / 176

Touch Panel Accessories
19 NXD/T-1200V Wall/Flush Mount Touch Panel
Step 4: Close and Resecure the NXT Panel Enclosure
1.
Obtain the I/O connector plate and slide it back into position (FIG. 21).
2.
Resecure the Stereo Output nut back onto the new Stereo Output jack onto the I/O plate.
3.
With the components securely installed, tilt the LCD back to a 45° and gently slide-on the outer housing (towards
the LCD) until the it is aligned over the installation holes and the tilt bracket prevents any further forward
movement (FIG. 17).
4.
Gently press down on the housing (toward the base) until it is securely positioned over the circuit board and covers
base.
5.
While holding the outer housing and base plate in place, turn the panel back over until the LCD lies facedown on a
soft cloth and the under-side of the base is exposed.
6.
Insert and secure the eight Housing Screws (using a grounded Phillips-head screwdriver) into their respective
locations (FIG. 17).
7.
Replace any adhesive plastic "feet" that might have been removed during the removal process of the outer housing.
These "feet" must be placed back onto their original locations so they can fit into their provided openings on the
Battery Base.
8.
Grasp both the LCD and housing and then rotate the entire unit back onto a flat surface.
9.
Insert all connectors and apply power.
Installation and Upgrade of the Internal NXD Components
Upgrading the components within a WallMount panel involves removing the rear plastic outer housing (back box),
removing and/or installing an existing component, and then placing the back box back onto the NXD panel, as described
in the following sections.
Step 1: Remove the existing NXD Outer Housing
1.
Carefully detach all connectors from the side of the touch panel and remove the front magnetic faceplate from the
NXD unit by firmly gripping the faceplate and pulling outwards, while applying a small amount of pressure to
remove it from the main unit.
2.
Place the LCD facedown onto a soft cloth to expose the under-side of the unit (FIG. 23). This step helps prevent
scratching of the LCD.
3.
Unscrew the Stereo Output nut from the Stereo Output jack.
4.
Remove the I/O connector plate by using a grounded Phillips-head screwdriver to remove the two screws and slide
the I/O connector plate away from the back box housing.
Use caution when re-installing the outer housing. Improper re-installation can cause
damage to the internal speakers.