![background image](http://html1.mh-extra.com/html/amx/modero-nxd-1200v/modero-nxd-1200v_operation-reference-manual_2938937041.webp)
Installation Procedures: NXD-1200V Panels
29
NXD/T-1200V Wall/Flush Mount Touch Panel
Installation Procedures: NXD-1200V Panels
Overview
NXT panels are mounted onto flat (horizontal) surfaces in either a stand-alone or combo (NXT atop an NXA-BASE/B
battery base) configuration. NXD panels are installed into either a pre-wall surface (using a CB-TP12 conduit/wallbox)
or a solid surface (using either solid surface or drywall screws).
Unpacking the Panel
1.
Inspect and confirm the contents of the shipment box to verify that you have all specified parts. Refer to the
Specifications
table (page 2) for more information about included accessories and other AMX equipment.
2.
Carefully remove the panel from the shipping box.
3.
Carefully peel the protective plastic cover from the LCD.
Installing the Internal Components
Installation of the internal components such as the upgraded Compact Flash memory and NXA-PCI80211G Wireless
card are described in detail within the following sections:
Step 2: Install the 802.11g mini-PCI Wireless Card
section on page 16.
Step 3: Install the Compact Flash Memory Card upgrade
section on page 17.
Upgrading to the MB-TP12 VESA Mounting Kit
Upgrading the existing back box with the new VESA Mounting Kit on the 12" (
FG031-50
) panel requires 3 main
processes:
Removing the pre-existing back box and installing the new VESA back box.
Threading cables through the strain relief grommet opening in the rear plastic cover.
Finalizing the installation of the NXD (with VESA back box and cables) into the plastic cover, securing both
components, and finalizing the strain relief grommet installation.
Removing the Original Modero Back Box
1.
Detach all connectors from the side of the touch panel.
2.
Remove the magnetic faceplate from the NXD unit by gripping the faceplate and pulling outwards while applying a
small amount of pressure to remove it from the main unit.
3.
Place the LCD face-down on a soft cloth to expose the back of the panel and prevent scratching of the LCD.
4.
Unscrew the Stereo Output nut from the Stereo Output jack.
5.
Remove the I/O connector plate by using a grounded Phillips-head screwdriver to remove the two screws and slide
the I/O connector plate away from the back box housing.
It is recommended that if you are planning on upgrading your panel components
(flash card and wireless), you do so before beginning any panel installations.
If the protective plastic LCD cover is not removed, the panel may not respond
properly to touch points on the LCD or allow proper screen calibration.
Only overall dimensions and FG product numbers are different.
The new MB-TP Universal VESA Mounting Box uses a standard VESA installation
pattern of 75 mm between holes. VESA mounts that conform to this pattern can be
used on the MB-TP Housing.
Summary of Contents for Modero NXD-1200V
