Allied Vision Pike F-032B/C, Technical Manual

Page: 26 / 376

Pike Technical Manual V5.2.0
26
Introduction
continued from previous page
V5.1.2
[continued]
13.08.2012
[continued]
Changed IR cut filter to (type Jenofilt 217) :

see Figure 55: Approximate spectral transmission of IR cut filter
(may vary slightly by filter lot) (type Jenofilt 217) on page 103
Pike trigger input voltage (GPIn1 and GPIn2) changed from 2 V
to
3 V at min. input current of 5 mA , see Chapter Camera I/O
connector pin assignment on page 108.
V5.1.3 19.11.2012 Corrected register offset of LOW_NOISE_BINNING (0xF10005B0
instead of 0xF1000580), see:
• Table 152: Advanced registers summary on page 315
• Table 181: Advanced register: Low-noise binning mode on
page 346
• Chapter Index
V5.2.0 09.03.2015 Updated data:
• Corrected hyperlinks to targets on the Allied Vision website
• Removed outdated information in Chapter Requirements
for PC and 1394b on page 41
• Added hyperlink to FireWire accessories on the Allied Vision
website in Chapter
Requirements for PC and 1394b on page
41
• Removed information on the Universal Package in Chapter
Operating system support on page 44
• Reduced to the current information on the system require-
ments in Chapter
Operating system support on page 44
• Added information that all color modes in Chapter Specifi-
cations on page 45 comply with the IIDC specifications
• Updated sensor curves in Chapter Spectral sensitivity on
page 58.
• Corrected information in Chapter Sensor position accuracy
of Pike cameras on page 366
• Adapted addresses in Chapter Contacting Allied Vision on
page 12
• Corrected information for binning in Chapter Definition on
page 165.
Layout changes due to a changed Corporate identity:
• Replaced the previous Allied Vision logo by the current one
• Reworded all appropriate contents from AVT and Allied
Vision Technologies to Allied Vision
Version Date Remarks
Table 1: Document history