AirLive IGR-842PoE, User Manual, Page: 99 / 299

5. Web Management: Monitor of IGR-842POE
AirLive IGR-842POE User Manual
94
Specify the TCP/UDP source filter for this ACE.
When "Specific" is selected for the EtherType filter, you can enter a specific
EtherType value. The allowed range is
0x600 to 0xFFFF but excluding
0x800(IPv4), 0x806(ARP) and 0x86DD(IPv6). A frame that hits this ACE matches
this EtherType value.
Buttons:
Save – Click to save changes.
Reset – Click to undo any changes made locally and revert to previously saved
values.
Cancel – Return to the previous page
4.5.2.4. IP Source Guard
4.5.2.4.1. Configuration
The section describes to configure the IP Source Guard detail parameters of the switch.
You could use the IP Source Guard configure to enable or disable with the Port of the
switch.
Web Interface
To configure an IP Source Guard Configuration in the web interface:
1. Select “Enabled” in the Mode of IP Source Guard Configuration.
2. Select “Enabled” of the specific port in the Mode of Port Mode Configuration.
3. Select Maximum Dynamic Clients (0, 1, 2, Unlimited) of the specific port in the Mode
of Port Mode Configuration.
4. Click Apply.