AirLive IGR-842PoE, User Manual, Page: 260 / 299

5. Web Management: Monitor of IGR-842POE
255
AirLive IGR-842POE User Manual
4. Mode:
Indicates the filtering mode maintained per (VLAN ID, port number, Group
Address) basis. It can be either Include or Exclude.
5. Source Address:
IP Address of the source. Currently, system limits the total number of IP source
addresses for filtering to be 128.
6. Type:
Indicates the Type. It can be either Allow or Deny.
7. Hardware Filter/Switch:
Indicates whether data plane destined to the specific group address from the
source IPv4 address could be handled by chip or not.
Button :
Auto-Refresh – Check this box to refresh the page automatically. Automatic
refresh occurs every 3 seconds.
Refresh –Refreshes the displayed table starting from the input fields.
|<< – Updates the table starting from the first entry in the MLD SFM Information
Table.
>> –Updates the table, starting with the entry after the last entry currently
displayed.
5.11 LLDP
The switch supports the LLDP. For current information on your switch model, The Link
Layer Discovery Protocol (LLDP) provides a standards-based method for enabling switches
to advertise themselves to adjacent devices and to learn about adjacent LLDP devices. The
Link Layer Discovery Protocol (LLDP) is a vendor-neutral Link Layer protocol in the Internet
Protocol Suite used by network devices for advertising their identity, capabilities, and
neighbors on a IEEE 802 local area network, principally wired Ethernet. The protocol is
formally referred to by the IEEE as Station and Media Access Control Connectivity
Discovery specified in standards document IEEE 802.1AB.
5.11.1. Neighbors
This page provides a status overview for all LLDP neighbors. The displayed table contains
a row for each port on which an LLDP neighbor is detected. The columns hold the following
information.
Web interface
To configure LLDP in the web interface:
1. Click Monitor, LLDP, Neighbors.
2. If you want to auto-refresh the information then you need to evoke the
“Auto-refresh”.
3. Click “Refresh“ to refresh the LLDP Neighbors.