AirLive IGR-842PoE, User Manual, Page: 112 / 299

5. Web Management: Monitor of IGR-842POE
107
AirLive IGR-842POE User Manual
4. TCP/UDP Port Number :
The TCP/UDP port number can be used to calculate the destination port for the
frame. Check to enable the use of the TCP/UDP Port Number, or uncheck to
disable.
By default, TCP/UDP Port Number is enabled.
Aggregation Group Configuration
1. Group ID :
Indicates the group ID for the settings contained in the same row. Group ID
"Normal" indicates there is no aggregation. Only one group ID is valid per port.
2. Port Member :
Each switch port is listed for each group ID. Select a radio button to include a port
in an aggregation, or clear the radio button to remove the port from the
aggregation. By default, no ports belong to any aggregation group. Only full
duplex ports can join an aggregation and ports must be in the same speed in each
group.
Buttons
Save – Click to save changes.
Reset - Click to undo any changes made locally and revert to previously saved
values.
4.6.2. LACP Aggregation
This page allows the user to inspect the current LACP port configurations, and possibly
change them as well An LACP trunk group with more than one ready member-ports is a
“real trunked” group. An LACP trunk group with only one or less than one ready
member-ports is not a “real trunked” group.
Web Interface
To configure the Trunk Aggregation LACP parameters in the web interface:
1. Click Configuration, LACP, Configuration.
2. Evoke to enable or disable the LACP on the port of the switch.
Scroll the Key parameter with Auto or Specific Default is Auto.
3. Scroll the Role with Active or Passive. Default is Active.
4. Click the save to save the setting.
5. If you want to cancel the setting then you need to click the Reset button. It will
revert to previously saved values