AirLive IGR-842PoE, User Manual, Page: 90 / 299

5. Web Management: Monitor of IGR-842POE
85
AirLive IGR-842POE User Manual
[policy_value & policy_bitmask]. For example, if the policy value is 3 and the policy
bitmask is 0x10(bit 0 is "don't-care" bit), then policy 2 and 3 are applied to this rule.
5. Frame Type :
Select the frame type for this ACE. These frame types are mutually exclusive.
Any : Any frame can match this ACE.
Ethernet Type : Only Ethernet Type frames can match this ACE. The IEEE 802.3
describes the value of Length/Type Field specifications to be greater than or equal
to 1536 decimal (equal to 0600 hexadecimal).
ARP : Only ARP frames can match this ACE. Notice the ARP frames won't match
the ACE with ethernet type.
IPv4 : Only IPv4 frames can match this ACE. Notice the IPv4 frames won't match
the ACE with ethernet type.
IPv6 : Only IPv6 frames can match this ACE. Notice the IPv6 frames won't match
the ACE with Ethernet type.
6. Action :
Specify the action to take with a frame that hits this ACE.
Permit : The frame that hits this ACE is granted permission for the ACE operation.
Deny : The frame that hits this ACE is dropped.
Filter : Frames matching the ACE are filtered.
7. Rate Limiter :
Specify the rate limiter in number of base units. The allowed range is 1 to 16 .
Disabled indicates that the rate limiter operation is disabled.
8. Port Redirect :
Frames that hit the ACE are redirected to the port number specified here. The rate
limiter will affect these ports. The allowed range is the same as the switch port
number range.
Disabled indicates that the port redirect operation is disabled and
the specific port number of 'Port Redirect' can't be set when action is permitted.
9. Mirror :
Specify the mirror operation of this port. Frames matching the ACE are mirrored to
the destination mirror port. The rate limiter will not affect frames on the mirror port.
The allowed values are:
Enabled : Frames received on the port are mirrored.
Disabled : Frames received on the port are not mirrored.
The default value is "Disabled".
10. Logging :
Specify the logging operation of the ACE. Notice that the logging message doesn't
include the 4 bytes CRC information. The allowed values are:
Enabled : Frames matching the ACE are stored in the System Log.
Disabled : Frames matching the ACE are not logged.
Note: The logging feature only works when the packet length is less than
1518(without VLAN tags) and the System Log memory size and logging rate is
limited.