AirLive IGR-842PoE, User Manual, Page: 201 / 299

5. Web Management: Monitor of IGR-842POE
AirLive IGR-842POE User Manual
196
When GVRP is enabled a maximum number of VLANs supported by GVRP is
specified. By default this number is 20. This number can only be changed when
GVRP is turned off.
4. Timeout :
Save – Click to save changes.
5. Max. Datagram Size :
Save – Click to save changes.
Port Configuration
1. Port :
The port number for which the configuration below applies.
2. Flow Sample Enabled :
Enables/disables flow sampling on this port.
3. Flow Sampler Sampling Rate :
The statistical sampling rate for packet sampling. Set to N to sample on average
1/Nth of the packets transmitted/received on the port.
Not all sampling rates are achievable. If an unsupported sampling rate is
requested, the switch will automatically adjust it to the closest achievable. This will
be reported back in this field.
4. Flow Sample Max. Header :
Save – Click to save changes.
The maximum number of bytes that should be copied from a sampled packet to
the sFlow datagram. Valid range is 14 to 200 bytes with default being 128 bytes.
If the maximum datagram size does not take into account the maximum header
size, samples may be dropped.
5. Counter Poller Enabled :
Enables/disables counter polling on this port.
6. Counter Poller Interval :
With counter polling enabled, this specifies the interval - in seconds – between
counter poller samples.
Button :
Release – See description under Owner.
Refresh – Click to refresh the page. Note that unsaved changes will be lost.
Save – Click to save changes. Note that sFlow configuration is not persisted to
non-volatile memory.
Reset –Click to undo any changes made locally and revert to previously saved
values.