Page
5
of
92
MAN177 rev_08_21_2018
1.) Safety Information
General Power Tool Safety Warnings
WARNING Read all safety warnings and instructions.
Failure to follow the warnings and
instructions may result in electric shock, fire, and/or serious injury.
Save all warnings and instructions for future reference.
The term “power tool” in the warnings refers to your mains
-operated (corded) power tool or
battery-operated (cordless) power tool.
1.
Work area safety
a.
Keep work area clean and well lit.
Cluttered or dark areas invite accidents.
b.
Do not operate power tools in explosive atmospheres, such as in the presence of
flammable liquids, gases or dust.
Power tools create sparks which may ignite the
dust or fumes.
c.
Keep children and bystanders away while operating a power tool.
Distractions can
cause you to lose control.
2.
Electrical safety
a.
Power tool plugs must match the outlet. Never
modify the plug in any way.
Do not use any adapter
plugs with earthed (grounded) power tools.
Unmodified plugs and matching outlets will reduce
risk of electric shock.
b.
Avoid body contact with earthed or grounded
surfaces, such as pipes, radiators, ranges and
refrigerators.
There is an increased risk of electric
shock if your body is earthed or grounded.
c.
Do not expose power tools to rain or wet conditions.
Water entering a power tool will increase the risk of
electric shock.
d.
Do not abuse the cord. Never use the cord for carrying, pulling or unplugging the
power tool. Keep cord away from heat, oil, sharp edges or moving parts.
Damaged
or entangled cords increase the risk of electric shock.
e.
When operating a power tool outdoors, use an extension cord suitable for outdoor
use.
Use of a cord suitable for outdoor use reduces the risk of electric shock.
f.
If operating a power tool in a damp location is unavoidable, use a residual current
device (RCD) protected supply.
Use of an RCD reduces the risk of electric shock.
NOTE:
The term “residual current device (RCD)” may be replaced by the term
“ground fault circuit interrupter (GFCI)” or “earth leakage current breaker (ELCB)”.
IEC 320-C20
N/L2 L1
PE
Note: AC Supply
voltage must be within
+/- 10% of voltage
specified on the
controller label
Power Cord Receptacle
