Page
10
of
92
3.) Initial Set Up
Step 1:
Connect Sensor Cable to CN-1 Connector of IPC Controller and connect Amphenol
Connector to the tool.
Step 2:
Plug female end of power cable into Power Cable Connector.
Step 3:
Plug male end of power cable into appropriate power source.
Connection to local power should be made in consultation with a qualified
electrician.
Step 4:
The Secondary Protective Earth Attachment (required) must be connected to ground
using the #14 AWG conductor, a green wire with a yellow stripe. Attach using a #10-14AWG ring
terminal and #10 star washer (see below).
1
Secondary Protective Earth Attachment
Step 5:
Turn controller on by pushing the Power Disconnect Switch to the POWER ON
position, a light indicates power on.
