Agilent Technologies InfiniiVision 2000 X-Series, Programmer'S Manual, Page: 5 / 930

Agilent InfiniiVision 2000 X-Series Oscilloscopes Programmer's Guide 5
• Chapter 25 , “:SBUS<n> Commands,” starting on page 447, describes
commands that control oscilloscope functions associated with the serial
decode bus and serial triggering.
• Chapter 26 , “:SEARch Commands,” starting on page 531, describes
commands that control oscilloscope functions associated with searching
for waveform events.
• Chapter 27 , “:SYSTem Commands,” starting on page 563, describes
commands that control basic system functions of the oscilloscope.
• Chapter 28 , “:TIMebase Commands,” starting on page 577, describes
commands that control all horizontal sweep functions.
• Chapter 29 , “:TRIGger Commands,” starting on page 589, describes
commands that control the trigger modes and parameters for each
trigger type.
• Chapter 30 , “:WAVeform Commands,” starting on page 627, describes
commands that provide access to waveform data.
• Chapter 31 , “:WGEN Commands,” starting on page 663, describes
commands that control waveform generator (Option WGN) functions and
parameters.
• Chapter 32 , “:WMEMory<r> Commands,” starting on page 693, describes
commands that control reference waveforms.
• Chapter 33 , “Obsolete and Discontinued Commands,” starting on page
703, describes obsolete commands which still work but have been
replaced by newer commands and discontinued commands which are no
longer supported.
• Chapter 34 , “Error Messages,” starting on page 751, lists the instrument
error messages that can occur while programming the oscilloscope.
The command descriptions in this reference show upper and lowercase
characters. For example, :AUToscale indicates that the entire command
name is :AUTOSCALE. The short form, :AUT, is also accepted by the
oscilloscope.
Then, there are chapters that describe programming topics and conceptual
information in more detail:
• Chapter 35 , “Status Reporting,” starting on page 759, describes the
oscilloscope's status registers and how to check the status of the
instrument.
• Chapter 36 , “Synchronizing Acquisitions,” starting on page 779,
describes how to wait for acquisitions to complete before querying
measurement results or performing other operations with the captured
data.
• Chapter 37 , “More About Oscilloscope Commands,” starting on page 789,
contains additional information about oscilloscope programming
commands.
Finally, there is a chapter that contains programming examples: