Agilent Technologies InfiniiVision 2000 X-Series, Programmer'S Manual, Page: 467 / 930

:SBUS<n> Commands
25
Agilent InfiniiVision 2000 X-Series Oscilloscopes Programmer's Guide 467
:SBUS<n>:CAN:TRIGger:PATTern:ID
(see page 790 )
Command Syntax
:SBUS<n>:CAN:TRIGger:PATTern:ID <string>
<string> ::= "nn...n" where n ::= {0 | 1 | X | $}
<string ::= "0xnn...n" where n ::= {0,..,9 | A,..,F | X | $}
The :SBUS<n>:CAN:TRIGger:PATTern:ID command defines the CAN
identifier pattern resource according to the string parameter. This pattern,
along with the identifier mode (set by the
:SBUS<n>:CAN:TRIGger:PATTern:ID:MODE command), control the identifier
pattern searched for in each CAN message.
If the string parameter starts with "0x", it is a hexadecimal string made up
of hexadecimal and X (don't care) characters; otherwise, it is a binary
string made up of 0, 1, and X (don't care) characters.
Query Syntax
:SBUS<n>:CAN:TRIGger:PATTern:ID?
The :SBUS<n>:CAN:TRIGger:PATTern:ID? query returns the current settings
of the specified CAN identifier pattern resource in the 29- bit binary string
format.
Return Format
<string><NL> in 29-bit binary string format
Errors • "- 241, Hardware missing" on page 753
See Also
• "Introduction to :TRIGger Commands" on page 589
• ":SBUS<n>:CAN:TRIGger:PATTern:ID:MODE" on page 468
• ":SBUS<n>:CAN:TRIGger:PATTern:DATA" on page 465
N O T E
The ID pattern resource string is always 29 bits. Only 11 of these bits are used when the
:SBUS<n>:CAN:TRIGger:PATTern:ID:MODE is STANdard.
A string longer than 29 bits is truncated to 29 bits when setting the ID pattern resource.