ABB FPBA-01 PROFIBUS DP, User Manual

Page: 38 / 196

38 Start-up
FPBA-01 configuration parameters – group A (group 1)
Note: The actual parameter group number depends on the drive
type. Group A (group 1) corresponds to:
•
parameter group 51 in ACSM1, ACS355, ACS380, ACS580,
ACS850 and ACQ810
•
parameter group 51 in ACS880 and ACS880-M04 if the
adapter is installed as fieldbus adapter A or group 54 if the
adapter is installed as fieldbus adapter B.
No. Name/Value Description Default
01 FBA type Read-only. Shows the fieldbus
adapter type as detected by the
drive. The value cannot be
adjusted by the user.
If the value is
0 = None, the
communication between the drive
and the module has not been
established.
1 =
Profibus_
DP
02 Node address Each device on the PROFIBUS
network must have a unique node
number. This parameter defines a
node number for the drive the
module is connected to.
Recommended node numbers are
3 to 125 inclusive. 3
0…126 Node number
03 Baud rate Read-only. Indicates the detected
communication speed in kbit/s.
1)
Default value is 0 if there is no
connection.
1500
1)
12000 12 Mbit/s
6000 6 Mbit/s
3000 3 Mbit/s
1500 1.5 Mbit/s
500 500 kbit/s
187 187.5 kbit/s