160 Communication protocol
The table below shows the PROFIdrive parameter request error
codes
.
Error #
Meaning
Used at
00h
Impermissible
parameter number
Access to an unavailable parameter
01h
Parameter value cannot
be changed
Change access to a parameter
value that cannot be changed
02h
Low or high limit
exceeded
Change access with a value outside
the limits
03h
Invalid subindex
Access to an unavailable subindex
04h
No array
Access with a subindex to a non-
indexed parameter
05h
Incorrect data type
Change access with a value that
does not match the data type of the
parameter
06h
Setting not permitted
(can only be reset)
Change access with a value
unequal to 0 when this is not
permitted
07h
Description element
cannot be changed
Change access to a description
element that cannot be changed
09h
No description data
available
Access to an unavailable
description (Parameter value is
available.)
0Bh
No operation priority
Change access rights without rights
to change parameters
0Fh
No text array available
Access to a text array that is not
available (Parameter value is
available.)
11h
Request cannot be
executed because of
operating mode
Access is temporarily not possible
for reasons that are not specified in
detail.
14h
Value impermissible
Change access with a value that is
within limits but is not permissible
for other long-term reasons
(parameter with defined single
values)
Summary of Contents for FPBA-01 PROFIBUS DP
