38 Start-up
FEPL-02 configuration parameters – group B (group 2)
Note:
The actual parameter group number depends on the drive
type. Group B (group 2) corresponds to:
•
parameter group
55
in ACS355
•
parameter group
53
in ACSM1, ACS380, ACS580 and
ACS850
•
parameter group
53
in ACS880 if the adapter is installed as
fieldbus adapter A or group
56
if the adapter is installed as
fieldbus adapter B.
All parameters in this group are handled by the adapter module
automatically. Do not modify the settings of these parameters.
FEPL-02 configuration parameters – group C (group 3)
Note:
The actual parameter group number depends on the drive
type. Group C (group
3
) corresponds to:
•
parameter group
54
in ACS355
•
parameter group
52
in ACSM1, ACS380, ACS580 and
ACS850
•
parameter group
52
in ACS880 if the adapter is installed as
fieldbus adapter A or group
55
if the adapter is installed as
fieldbus adapter B.
All parameters in this group are handled by the adapter module
automatically. Do not modify the settings of these parameters.
Summary of Contents for FEPL-02 Ethernet POWERLINK
