Start-up 39
Control locations
ABB drives can receive control information from multiple sources
including digital inputs, analog inputs, the drive control panel and a
communication module (for example, the adapter module). ABB
drives allow the user to separately determine the source for each
type of control information (Start, Stop, Direction, Reference, Fault
reset, etc.).
To give the fieldbus master station the most complete control over
the drive, the communication module must be selected as the
source for this information. The drive-specific parameter setting
examples below contain the drive control parameters needed in
the examples. For a complete parameter list, see the drive
documentation.
Summary of Contents for FEPL-02 Ethernet POWERLINK
