Zte ZXR10 GER, Руководство пользователя

Страница: 227 / 412

Chapter 14 OSPF Configuration
Confidential and Proprietary Information of ZTE CORPORATION 205
Refer to below procedure for configuration of redistribution of
other routing protocols into OSPF.
„
Router Command Line Interface has been accessed.
„
OSPF is running on a network as described in above basic
OSPF configuration.
1. Use the redistribute command to control the redistribution
of routes of other routing protocols into an OSPF autonomous
system in OSPF route mode as shown in Table 249.
T
A B L E
2 4 9 R
E D I S T R I B U T E
C
O M M A N D
Command
Format
Command
Mode
Command Function
redistribute
<protocol> [as
<as-no>] [peer
<peer-address>]
[tag <tag-value>]
[metric <value>]
[ metric-type
< type> ] [ route-
map < map-tag >]
Route
This controls the
redistribution of routes
(these routes meet the
relative conditions) of
other protocols into an
OSPF autonomous system.
After the command is
carried out, the router
becomes an ASBR
Result: This establish a process of redistribution of other
routing protocols into OSPF.
E
ND OF STEPS
For additional information on OSPF additional configurations,
please refer to below procedures.
Configuring Administrative Distance
The administrative distance stands for the reliability of
information source. Normally, the administrative distance is an
integer ranging from 0 to 255. Higher value indicates lower
reliability. If the administrative distance is 255, it indicates that
the source of the routing information is unreliable, so the related
route will be neglected.
ZXR10 GER can define the administrative distances of three
types of routes of OSPF: Internal route, external route type 1
and external route type 2. By default, the administrative of all
the three types of routes are 110.
Refer to below procedure for configuration of redistribution of
other routing protocols into OSPF.
„
Router Command Line Interface has been accessed.
„
OSPF is running on a network as described in above basic
OSPF configuration.
1. For modifying the administrative distance of OSPF, use
distance ospf {[ internal < distance> ] [ ext1 < distance> ]
Prerequisites
Steps
Related
Information
Introduction
Purpose
Prerequisites
Steps