Zte ZXR10 GER, Руководство пользователя

Страница: 283 / 412

Chapter 17 Policy Routing Configuration
Confidential and Proprietary Information of ZTE CORPORATION 261
Result: This defines the default route when destination is
not obtained.
7. To route the data packet to the default interface, use set
default interface command in route mapping configuration
mode, as shown in Table 311.
T
A B L E
3 1 1 S
E T
D
E F A U L T
I
N T E R F A C E
C
O M M A N D
Result: This enables to route the data packet to the default
interface.
8. To configure rapid forwarding based on the policy routing for
the incoming messages of the port, use ip policy route-
map command in route mapping configuration mode, as
shown in Table 312.
T
A B L E
3 1 2 I
P
P
O L I C Y
R
O U T E
- M
A P
C
O M M A N D
Result: This configures the rapid forwarding based on the
policy routing for the incoming messages of the port.
E
ND OF STEPS
Example:
When there are many Internet Service Provider (ISP) egresses
on the network, select different ISP egresses for users from
different groups through policy routing, or select different ISP
egresses based on service types.
As shown in Figure 105, the router accesses the users of two
subnets through different interfaces. Two ISP egresses are
available, and users with different IP addresses need to select
different egresses. The users in the subnet with the IP address
10.10.0.0/24 select ISP1 egress and those in the subnet with
the IP address 11.11.0.0/24 select ISP2 egress.
Command
Format Command
Mode
Command Function
set default
interface
route
mapping
configuration
This enables to route the
data packet to the default
interface
Command
Format Command
Mode
Command Function
ip policy route-
map
route
mapping
configuration
This configures the rapid
forwarding based on the
policy routing for the
incoming messages of the
port