Zte ZXR10 GER, Руководство пользователя

Страница: 149 / 412

Chapter 8 Smart Group Configuration
Confidential and Proprietary Information of ZTE CORPORATION 127
T
A B L E
1 5 1 B
I N D
C
O M M A N D
Command Format
Command
Mode Command Function
interface
smartgroup<
smartgrup
no >
Interface
config
This bind the link
Result: This bind the link.
.3. To configure the load sharing function on the SMARTGROUP
interface, use
smartgroup load-balance command in
interface configuration mode, as shown in Table 152.
T
A B L E
1 5 2 S
M A R T
G
R O U P
L
O A D
B
A L A N C E
C
O M M A N D
Command
Format Command
Mode Command Function
smartgroup
load-
balance
Interface
config
This configures the load sharing
function on the SMARTGROUP
interface
Result: This configures the load sharing function on the
SMARTGROUP interface.
.4. To implement the ACL function on the SMARTGROUP
interface, use
ip access-group command in interface
configuration mode, as shown in Table 153.
T
A B L E
1 5 3 I
P
A
C C E S S
G
R O U P
C
O M M A N D
Command
Format
Command
Mode
Command Function
ip access-
group
Interface
config
This implements the ACL
function on the SMARTGROUP
interface
Result: This implements the ACL function on the
SMARTGROUP interface.
ND OF STEPS
Example:
Figure 72 shows the SMARTGROUP configuration example. The
fei_2/1~fei_2/3 interface of the RA is connected to the
fei_2/1~fei_2/3 interface of the RB respectively. Bind the
interfaces to the smartgroup, and connect the fei_1/1 interface
of RA and RB to the SMARTBITS tester.