Zte ZXR10 GER, Руководство пользователя

Страница: 316 / 412

ZXR10 GER (V2.6.03) General Excellent Router User Manual Volume-I
294 Confidential and Proprietary Information of ZTE CORPORATION
For this process, use the network command to define an
interface connected to CE, and execute route redistribution
from BGP to RIP. For example:
ZXR10(config)#router ospf 1
ZXR10(config-router)#network 10.0.0.0 0.255.255.255
area 0.0.0.0
ZXR10(config)#router ospf 2 vrf test1
ZXR10(config-router)#network 10.10.10.1 0.0.0.0 area
0.0.0.0
ZXR10(config-router)#redistribute bgp_int
For the BGP, it is only necessary to designate a CE peer in
the address-family ipv4 vrf address of the BGP.
T
A B L E
3 4 0 A
D D R E S S F A M I L Y
C
O M M A N D
Command
Format Command
Mode Command Function
address-
family ipv4
vrf <vrf-
name>
Route This enters BGP address mode
Result: This enters BGP address mode.
EBGP runs between PE and CE that belong to different ASs.
In the current version, it is recommended that a directly-
connected address be used as the link setup address, for
example:
ZXR10(config)#router bgp 100
ZXR10(config-router)#neighbor 10.10.3.3 remote-as 100
ZXR10(config-router)#neighbor 10.10.3.3 update-source
loopback1
ZXR10(config-router)#address-family ipv4 vrf test1
ZXR10(config-router-af)#redistribute connected
ZXR10(config-router-af)#neighbor 10.1.1.2 remote-as 200
ZXR10(config-router-af)#exit-address-family
ZXR10(config-router)#address-family vpnv4
ZXR10(config-router-af)#neighbor 10.10.3.3 activate
ZXR10(config-router-af)#exit-address-family
5. To configure MPBGP, following steps are required:
After learning a VRF route from CE, the PE should advertise the
route to other PEs. In this case, MPBGP should be configured
in the following three steps:
i. In BGP route configuration mode, use the
neighbor
command to designate a PE peer.
ii. Enter the address-familary vpnv4 address mode of the
BGP and activate the peer.