Zte ZXR10 GER, Руководство пользователя

Страница: 148 / 412

ZXR10 GER (V2.6.03) General Excellent Router User Manual Volume-I
126 Confidential and Proprietary Information of ZTE CORPORATION
Ethernet interfaces can be bound to a SMARTGROUP logic
interface:
Functions of the SMARTGROUP are as follows:
„
It supports the binding of Ethernet interfaces on the same
interface card.
„
For different interface cards, it only supports the binding of
Ethernet interfaces of the same IQ.
„
Load sharing supports two modes: per-packet and per-
destination. The per-destination mode considers the source
IP address and destination IP address.
„
It supports various routing protocols: RIP (with low priority),
BGP, OSPF and ISIS. That is, these routing protocols can be
run in the SmartGroup interface.
„
It supports MPLS and VPN access.
„
It also supports NAT, ACL, QoS and VRRP.
In the ZXR10 GER system:
„
Up to 64 SmartGroup interfaces can be configured.
„
Each SMARTGROUP interface can bind a maximum of eight
Ethernet interfaces of the same type and the same rate.
„
The throughput after binding is slightly different from the
throughput of each interface and 10% is targeted.
Configuring SMARTGROUP
Refer to below procedure for configuring smartgroup on ZTE
ZXR10 GER router.
Router Command Line Interface has been accessed.
1.
To create a SMARTGROUP interface, use interface
smartgroup command in interface configuration mode, as
shown in Table 150.
T
A B L E
1 5 0 S
M A R T
G
R O U P
C
O M M A N D
Command
Format Command
Mode Command Function
interface
smartgroup Interface
config This creates a SMARTGROUP
interface
Result: This creates a SMARTGROUP interface.
. 2. To bind the link, use interface smartgroup< smartgrup
no > command in interface configuration mode, as shown in
Table 151.
Purpose
Prerequisite
Steps