Zte ZXR10 GER, Руководство пользователя

Страница: 201 / 412

Chapter 13 RIP Configuration
Confidential and Proprietary Information of ZTE CORPORATION 179
current routing protocol to use the same metric value for all
redistributed routes.
A default metric helps solve the problem of redistributing routes
with incompatible metrics. Whenever metrics do not
convert,
using a default metric provides a reasonable substitute and
enables the redistribution to proceed.
Important! When enabled, the default-metric command applies
a metric value of 0 to redistributed connected routes. The
default-metric command does not override metric values that
are applied with the redistribute command.
Result: This helps to configure metric values for other routing
protocols.
E
ND OF STEPS
ZXR10 GER supports RIPv1 and RIPv2 (RIPv2 is used by default).
1. To specify a RIP version used globally by the router, use
version command in RIP router configuration mode, as
shown in Table 220. Use the no form of this command to
restore the default value.
T
A B L E
2 2 0 R
I P
V
E R S I O N
C
O M M A N D
W
I N D O W
Command
Format
Command
Mode
Command Function
version { 1|2 } RIP Config This designates the RIP
version used in a router
globally
ip rip receive
version
{ 1|2 }
[ 1|2 ]
RIP Config This designates the RIP
version received on an
interface
ip rip send
version { 1|2
{ broadcast
multicast }}
RIP Config
This designates the RIP
version sent on an interface
{ 1|2 } specifies RIP version 1 and RIP version 2.
To specify RIP versions used on an interface basis, use
the
ip rip receive version and ip rip send version
commands.
ip rip receive version command is used to override the
default behavior of RIP as specified by the version command.
This command applies only to the interface
configuration. There can be configuration for accepting both
the versions.
ip rip send version command to override the default
behavior of RIP as specified by the router version command.
This command applies only to the interface configuration.
Result: These commands specify RIP versions for receiving
and sending routing updates.
Default Metric
Version
Configuration