Zte ZXR10 GER, Руководство пользователя

Страница: 251 / 412

Chapter 16 BGP Configuration
Confidential and Proprietary Information of ZTE CORPORATION 229
„
Optional and transferable attributes: The attributes do
not need support in all BGP implementations. However, if an
attribute is supported, the attribute can be transferred to its
BGP neighbor, while attributes not supported by the current
router need to be continuously transferred to other BGP
routers.
f
Aggregator
f
Community
„
Optional and non-transferred attribute: The attribute
indicates that routers that do not support the attribute need
to be deleted.
f
Multi-Exit Discriminator (MED)
In addition to above attributes, the weight attribute (defined by
CISCO) is also a common attribute.
Basic BGP Configuration
Refer to below procedure for BGP configuration on ZTE ZXR10
GER.
Router Command Line Interface has been accessed.
1. Enter into configuration mode by writing
config terminal
command in global configuration mode as shown in Table
280.
T
A B L E
2 8 0 C
O N F I G
T
E R M I N A L
C
O M M A N D
Command
Format Command
Mode Command Function
config
terminal Exec Enters into global configuration
mode
Result: This enables to enter into global configuration mode.
2. To enable BGP, use router bgp < as-number> command in
global config mode as shown in Table 281.
T
A B L E
2 8 1 R
O U T E R
B
G P
C
O M M A N D
Command
Format
Command
Mode
Command Function
router
bgp < as-
number>
Global config This enables BGP routing process
Result: This establish BGP routing process.
3. To configure BGP neighbor for BGP communication, use
neighbor < ip-address > remote-as < number > command in
BGP route mode as shown in Table 282.
Purpose
Prerequisite
Steps