Zte ZXR10 GER, Руководство пользователя

Страница: 142 / 412

ZXR10 GER (V2.6.03) General Excellent Router User Manual Volume-I
120 Confidential and Proprietary Information of ZTE CORPORATION
1. To configure the forwarding mode of an interface, use ip
forwarding-mode command in interface configuration
mode, as shown in Table 145.
T
A B L E
1 4 5 I
P
F
O R W A R D I N G
M
O D E
Command
Format
Command
Mode
Command Function
ip
forwarding-
mode
Interface
config
This configures the forwarding
mode of an interface
Result: This configures the forwarding mode of an interface.
. 2. To configure the forwarding table of the V_Switch, use vlan-
forwarding ingress command in interface configuration
mode, as shown in Table 146.
T
A B L E
1 4 6 V
L A N
F
O R W A R D I N G
I
N G R E S S
Command
Format
Command
Mode
Command Function
vlan-
forwarding
ingress
Interface
config
This configures the forwarding
table of the V_Switch
Result: This configures the forwarding table of the V_Switch.
E
ND OF STEPS
Example:
The following takes the Ethernet interface as an example to
introduce V_Switch configuration. For detailed V_Switch
transparent transmission configurations of the POS and ATM
interfaces, refer to “Chapter 10
Bridge Configuration”. As shown in Figure 71, the fei_1/3
interface of the ZXR10 GER is connected to the user side of the
BAS and the fei_1/4 interface is connected to the network side
of the BAS.
The fei_1/3 interface of the ZXR10 GER connects PPPoE users
and the fei_1/2 interface connects dedicated line users. The
VLAN ID range of PPPoE users is 10~19. The corresponding
VLAN ID range at the user side of the BAS is 20~29 and that of
dedicated line users is 30~31.
Steps
Introduction
PPPoE
Connection