Yamaha WR250F(P), Руководство по эксплуатации для владельца

Страница: 224 / 694

3 - 28
INSP
ADJ
REAR BRAKE ADJUSTMENT/
FRONT BRAKE PAD INSPECTION AND REPLACEMENT
EC364002
REAR BRAKE ADJUSTMENT
1. Check:
●
Brake pedal height
a
Out of specification
→
Adjust.
Brake pedal height
a
:
5 mm (0.20 in)
2. Adjust:
●
Brake pedal height
Pedal height adjustment steps:
●
Loosen the locknut 1 .
●
Turn the adjusting nut 2 until the pedal
height
a
is within specified height.
●
Tighten the locknut.
WARNING
●
Adjust the pedal height between the
maximum
Å
and the minimum
ı
as
shown. (In this adjustment the bolt 3
end
b
should protrude out of the lower
adjusting nut 4 but not be less than
2 mm (0.08 in)
c
away from the brake
pedal 5 ).
●
After the pedal height adjustment, make
sure that the rear brake does not drag.
Å ı
FRONT BRAKE PAD INSPECTION AND
REPLACEMENT
1. Inspect:
●
Brake pad thickness
a
Out of specification
→
Replace as a
set.
2. Replace:
●
Brake pad
Brake pad thickness:
4.4 mm (0.17 in)
<Limit>: 1.0 mm (0.04 in)
Brake pad replacement steps:
●
Remove the pad pin plug 1 .