Woodward ProAct P Series FL, Инструкция по установке, программированию и устранению неисправностей, Страница: 55 / 110

Manual 26659 ProAct P-Series FL Position Controller
Woodward 45
Configuring the Unit—On-Line
Unit On-Line configuration is summarized as follows:
1. Open the Configuration Editor Dialog by selecting ‘File/Open Control
Configuration’.
2. Edit the configuration settings.
3. Load the configuration to the actuator.
As changes are made to Configuration parameters, the driver does
not use them until a ‘load’ command is issued. Selecting the ‘Cancel’
button closes the Configuration Editor and does not make any
changes to the driver.
Configuring the Unit—Off-Line
Unit Off-Line configuration is summarized as follows:
1. Open the Configuration Editor Dialog using the ‘File/New Configuration’ or
‘File/Open Configuration File’
2. Edit the configuration settings.
3. Save the configuration to a file. At a later date simply open the configuration
and load it into the actuator.
Configuration Parameters
There are 8 different screens that display the device’s configuration settings:
Setup, CAN, PWM, Analog In, Analog Out, Discrete I/O, Alarm/Shutdown, and
Position.