Wintriss AutoSet PAC 120 VAC, Руководство пользователя

Страница: 82 / 156

1101600 AutoSetPAC User Manual
82 Chapter 3 Initialization and Calibration
set to “ZERO SET.” Then turn power on again and check the displays. If the displays are still
inactive, call Wintriss Tech. Support.
7. Locate the dial indicators labelled “TONNAGE” (S1, S4, and S5 in Figure 3-15, S3, S4, and S5
in Figure 3-16) on the right side of the AutoSet processor board.
8. Each dial indicator has an arrow you can turn, using a small screwdriver, to the numerical setting
you want. The indicator labelled “100s” represents the hundreds position in the full-scale tonnage
setting, the indicator labelled “10s” represents the tens position, and the indicator labelled “1s”
represents the ones position. To set full-scale tonnage to 200, for example, as illustrated in Figure
3-18, you would turn the “100s” indicator to “2,” and turn the “10s” and “1s” indicators to “0.”
Figure 3-18. Tonnage Dial Indicators: Old-style Board (Left), New-style Board (Right)
9. Set the Tonnage dial indicators to twice the full-scale tonnage of one load cell.
NOTICE
Even if you are using two load cells for calibration, you still set the Tonnage dial indicators to
twice the full-scale tonnage of one load cell.
For tonnages greater than 999 (i.e., with more than three digits), set the dials to one-tenth of the
value you want. For example, to indicate a full-scale tonnage of 1200 tons, set the dials to “120”
(i.e., 120 x 10 = 1200).
AutoSet Load LED displays format tonnage readings based on two factors: the full-scale tonnage
you have specified on the dial indicators and the position of switch #3 on the Mode switch block
(S6 in Figure 3-15, S1 in Figure 3-16). Figure 3-19, page 82, shows the Mode switch block on
old-style AutoSet 2-Channel calibration kit processor boards. The switch block on new-style
boards is identical but labelled differently.
Figure 3-19.
Mode Switch #3 Set to “Decimal Point Off” Position (Old-style Processor Board)