Wintriss AutoSet PAC 120 VAC, Руководство пользователя

Страница: 120 / 156

1101600 AutoSetPAC User Manual
120 Chapter 5 Using AutoSetPAC in Run Mode
You should always recalculate setpoints when you have used the COPY TOOL function to create a
new tool number. The copied tool will have the same percentages and the same setpoints as the
original tool. If you create a new tool (not copying from an existing one), you do not have to
recalculate setpoints. AutoSetPAC will automatically calculate setpoints when you run the press.
CAUTION
Do not recalculate setpoints when the press is stopped due to a tonnage fault. Proceed only
when you have completely corrected the problem! Failure to do so may result in damage to the
press and tooling.
Failure to comply with these instructions could result in property damage.
Viewing Reverse Tonnage
When you select “SHOW REVERSE TONNAGE” on the Tonnage Monitor Run Menu, the screen
shown in Figure 5-15 displays.
Figure 5-15. Reverse Tonnage Plan View Screen
The Reverse Tonnage Plan View screen displays the reverse “snap-through” tonnage for each strain
link input and the total reverse tonnage for all strain link inputs. The reverse tonnage setpoint, which
is set in Initialization mode (see
Setting Reverse Setpoint % of Press Capacity
, page 68), is not shown
on this screen, and cannot be adjusted.
When you are done viewing this screen, press RESET to return to the Tonnage Monitor Run Menu.