Wintriss AutoSet PAC 120 VAC, Руководство пользователя

Страница: 110 / 156

1101600 AutoSetPAC User Manual
110 Chapter 5 Using AutoSetPAC in Run Mode
•
Yellow–Tonnage is within 25% of high or low setpoint
• Red–Tonnage exceeds high or low setpoint
Tonnage is also shown in numerical form next to each rectangular container. Tonnage readings are
shown in tenths of a ton (e.g., 27.8 tons) if the full-scale capacity of the press is less than 100 tons per
channel, as whole numbers (e.g., 28 tons) if full-scale capacity is 100 tons or greater.
To exit from the Tonnage Plan View screen, do one of the following:
• Press the F6 (Go to Reverse Plan View) function key to go to the Reverse Tonnage Plan
View screen (see Viewing Reverse Tonnage )
• Press the F7 (Go to Bargraph) function key to go to the Tonnage Bargraph View screen (see
next section)
• Press the F8 (Return to Main Menu) function key to return to the Main Run Menu
•
Press RESET to return to the Tonnage Monitor Run Menu
Displaying Tonnage in Bargraph View
When you select SHOW BARGRAPHS on the Tonnage Monitor Run Menu, the screen shown in
Figure 5-4 displays.
Figure 5-4.
Tonnage Bargraph View Screen
The Tonnage Bargraph View screen displays the current tonnage at each strain link as a vertical
magenta tick on a colored horizontal bar. The left end of the bar represents the low setpoint, the right
end the high setpoint. Tonnage is shown dynamically, the vertical tick mark moving left or right on
each bar as the tonnage recorded at each strain link changes from stroke to stroke.
The color of the bar indicates the proximity of the tonnage reading to high and low setpoints, as
follows: