URAL Motorcycles URAL-4320-60, Руководство по эксплуатации

Страница: 189 / 267

188
Description Technical requirements Recommended equipment,
accessories and tools Wheel ar-
rangement
4 х 4 6 х 6
Check fuel coarse filter
fastening
Fastening should be
tight
Wrench 14
х
17 + +
Check radiator unit fas-
tening
Ditto Wrench 17x19, pliers + +
Check air filter fastening -«- Screwdriver, wrench
10
х
12
+ +
Check tightening and re-
tighten the cooling system
clamps and engine starting
preheater clamps, if required
Coolant leakage is not
allowed
Wrench 7 х 9, screw-
driver
+ +
Check and retighten the
fuel pipeline nuts, if required
Fuel leakage is not al-
lowed
Wrench 24 х 27 + +
Drain sediment from fuel
tank
Fuel leakage through
drain plug is not allowed
Wrench 17x19, vessel,
wiping material
+ +
Change coolant in cooling
system (every three years)
Coolant level should be
near «M АХ » mark on the
expansion tank surface
Vessel with coolant,
wiping material
+ +
Filtering element of the
dry-type air filter should be
maintained upon the readings
of the clogging indicator but
at least at every maintenance
works. When operating in
conditions with high dust
content it should be serviced
more often on the basis of
operation experience in such
conditions
At the new filtering el-
ement installation check
visually its condition hav-
ing illuminating it from in-
side with the lamp. To
avoid carton tearing the
compressed air pressure
should be 200-300 kPa (2-
3 kgf/cm
2
) maximum. Air
stream should be directed
to the surface angularly,
stream force should be ad-
justed by changing the dis-
tance to element
Wrench 14
х
17, screw-
driver, vessel
+ +
Transmission
Check and adjust the sin-
gle-disk diaphragm clutch
pedal free and full travel (see
subsection «Clutch release
drive»), if required
For 4 х 4 and 6 х 6 trucks:
Clutch pedal free travel
should be within 5 – 10
mm. Full travel should be
within 185 - 190 mm.
Wrenches 17x19,
14x17, pliers, ruler
+ +