TransCore SmartPass AI1611, Системное руководство

Страница: 55 / 179

Chapter 3
Quick SmartPass
®
Test
This chapter provides instructions for testing SmartPass.
Overview
Before installing SmartPass at the site, you should perform two tests on SmartPass to
ensure that it will work properly. The first test is done using an audible circuit tester.
This test confirms that SmartPass has power, is communicating with the software
loaded inside the SmartPass reader, and can read a tag presented in the tag read zone.
The second test uses a personal computer (PC) and the SmartPass software diskette.
In this test you will check the factory defaults on your SmartPass and change the
defaults if needed. A list of the factory default settings on SmartPass is shown in
Table 3-5 located at the end of this chapter.
Materials Supplied
The SmartPass shipping carton is labeled to indicate the reader’s configuration.
Table 3-1 lists the simple three-letter code used.
Table 3-1 Three-Letter Reader Configuration Code
First Character Second Character Third Character
T = RS–232
F = RS–422
W = Wiegand H = High voltage
90–260 V AC S = Short cables
1.2 m
L = Long cables
6.1 m
This same three-letter code is stamped on the serial number plate on each SmartPass.
The code is followed by the frequency rate.
Example: A shipping carton labeled THS2450 contains a SmartPass that is
configured with RS–232, high-voltage power supply, and short cables and has an
operating frequency of 2450 MHz.
Your SmartPass is packaged with the materials listed below. Ensure you have
received all parts before beginning your quick test of SmartPass.
•
One SmartPass unit
•
One pole-mount bracket
•
Four machine screws and washers
3-3