TransCore SmartPass AI1611, Системное руководство

Страница: 135 / 179

SmartPass® Integrated Reader 2450 MHz (High Voltage) System Guide
Note: In the following table:
•
Items in bold italics identify factory default settings.
•
Only the data portion of the command number is shown.
•
Only the command-related data portion of the reader message is shown.
•
Refer to Chapter 8, “Communication Protocols,” for the complete syntax of
commands and messages.
Table 9-3 SmartPass Command List (Ordered by Command Name)
Command name Code Reader Message
All IDs Transmit 40 Done
Appended info status Display 524 IDAP Tx Dx Xx
T0 = time not appended
T1 = time appended
D0 = date not appended
D1 = date appended
X0 = aux info not appended
X1 = aux info appended
Aux info append Disable 310 Done or Error
Aux info append Enable 311 Done or Error
Basic protocol Select 610 Done or Error
Baud rate = 110 baud Set 1000 Done or Error
Baud rate = 1200 baud Set 1002 Done or Error
Baud rate = 19.2 K baud Set 1006 Done or Error
Baud rate = 2400 baud Set 1003 Done or Error
Baud rate = 300 baud Set 1001 Done or Error
Baud rate = 4800 baud Set 1004 Done or Error
Baud rate = 9600 baud Set 1005 Done or Error
Boot checksum Display 543 BCKS xxxx
xxxx = 4-byte ASCII checksum
Boot ROM checksum Verify 667 Done or Error
Buffer all IDs 43 Done
Buffer control mode Disable 6160 Done
Buffer control mode Enable 6161 Done
Buffer control status Display 535 BCM x
0 = disabled
1 = enabled
Buffer entry Transmit 06 Done, Error, or Tag Data
Done = buffer empty
Error = not in buffer control mode
Tag Data = highest priority tag ID
Check tag Select External 8161 Done
Check tag Select Internal 8160 Done
Check tag Invoke 8110 Done
9-12