TransCore SmartPass AI1611, Системное руководство

Страница: 143 / 179

SmartPass® Integrated Reader 2450 MHz (High Voltage) System Guide
100N Select Baud Rate
Command 100N selects the reader baud rate. The factory default setting is 9600
baud. The
N
variable specifies the baud rate as follows:
Table 9-4 Baud Rate specified by the N Variable
Command Baud Rate Selected
1000 110
1001 300
1002 1200
1003 2400
1004 4800
1005 9600
(factory default)
1006 19.2 K
The reader will transmit
Error
if the currently selected error correcting protocol
(ECP) timeout is not sufficient for the requested baud rate. The timeout will have to
be increased before the select baud rate command can be retransmitted.
Reader message:
Done or Error
101N Select Stop Bits
Command 101N selects the number of stop bits for reader character transmission.
The factory default setting is one stop bit. The
N
variable specifies the number of
stop bits as follows:
Table 9-5 Stop Bits specified by the N Variable
Command Stop Bits Selected
1010 1 (factory default)
1011 2
Reader message:
Done
102N Select Parity
Command 102N selects the reader parity setting. The factory default setting is parity
disabled. The
N
variable specifies parity as follows:
Table 9-6 Parity specified by the N Variable
Command Data Bits Parity Selected
1020 8 Disable parity (factory default)
1021 7 Select even parity
1022 7 Select odd parity
9-20