JUNE 2002 © TOSHIBA TEC
2 - 37
e-STUDIO550/650/810 ERROR CODES AND SELF-DIAGNOSIS
Level up of the fusing performance at the
continuous printing (reflected when the
“Thick paper 2” is selected)
0: Invalid 1: Valid
Level up of the fusing performance for
the 1st printing (reflected when the
“Thick paper 2” is selected)
0: Invalid 1: 1 sec. 2: 5sec.
3: 8 sec. 4: 10 sec. 5: 12 sec.
6: 15 sec. 7: 17 sec. 8: 20 sec.
9: 22 sec. 10: 25 sec.
Set to “Continuous mode” until laser unit
can be replaced.
Service call error codes;
CA3, CA5, CA6, CAA, CAB, CAC, CD0,
CE0, CE1, CE2, CE3 or CE4
(
Chapter 5.1.13.)
0: Normal mode - The laser unit
operates in this mode unless a service
call is indicated when the beam position
adjustment fails.
1: Continuous mode - Set to this mode
when the laser beam adjustment has
faild. The results of this setting places
the laser beam close to target even
though the beam position adjustment
has fails.
Setting of the new toner supply amount
to the developer unit
0: Normal amount
1: Normal amount x 1.5
2: Normal amount x 0.5
Setting of the recycle toner supply
amount to the developer unit
0: Normal amount
1: Normal amount x 1.5
2: Normal amount x 0.5
1
1
1
1
1
ALL
0
0~1
ALL
0
0~10
ALL
0
0~1
ALL
0
0~2
ALL
0
0~2
High-fusing mode 2
High-fusing mode 1
Temporar y laser
running service mode
when the laser beam
position adjustment fails
(*1)
Toner supply amount
setting/toner cartridge
motor control
Toner supply amount
setting/recycle toner
hopper motor control
433
434
449
455
456
Setting mode (08)
Acceptable
Operation
Value
procedure
Code
Name
Function
Default
Contents
(*1) 08-449
Due to the error of an optical component such as the galvanomirror or an error caused by the passing
time of the housing, if the beam positioning adjustment is not finished correctly an temporary
countermeasure will be brought about and a mode in which printing can continue to operate be applied.
(If the H-Sync is not taken, printing is impossible)
If there is an error in the galvanomirror, then correction control is not performed and “Service Call” is
displayed so the copier stops. When image deterioration is allowable, copier can be used without any
judgment as to whether adjustment has been finished or not. This can continue untill a replacement unit
is available and service technician can use this mode for that purpose.
Содержание e-studio550
Страница 115: ...JUNE 2002 TOSHIBA TEC 4 11 e STUDIO550 650 810 PREVENTIVE MAINTENANCE Rear side 20 74 75 32 80 63 44 73 75 53 ...
Страница 309: ...JUNE 2002 TOSHIBA TEC 8 1 e STUDIO550 650 810 WIREHARNESSCONNECTIONDIAGRAMS 8 WIRE HARNESS CONNECTION DIAGRAMS ...
Страница 313: ...1 1 KANDA NISHIKI CHO CHIYODA KU TOKYO 101 8442 JAPAN R02032112000 TTEC ...