JUNE 2002 © TOSHIBA TEC
3 - 27
e-STUDIO550/650/810 ADJUSTMENT
(3) Winding the wire around the pulleys
Wind the wire around the wire pulley:
a. Put the ø3 ball terminal located at the center of the wire into a hole on the wire pulley. One end of the
wire with a hook attached comes to the outside.
b. Wind the wires around the wire pulleys of the front and rear sides. The number of turns to be wound
are as follows:
· 2 turns toward the opposite side of the boss
· 5 turns toward the boss side
Note:
Pay attention to the following when the wires are wound around the pulleys:
·
Do not twist the wire.
·
Wind the wires tightly so that they are in complete contact with the surface of the pulleys.
·
Each turn should be pushed against the previously wound turn so that there is no space
between them.
Hook
Hook
No space between turns
Ball terminal
Ball terminal
2 turns
2 turns
5 turns
5 turns
Silver
Black
Содержание e-studio550
Страница 115: ...JUNE 2002 TOSHIBA TEC 4 11 e STUDIO550 650 810 PREVENTIVE MAINTENANCE Rear side 20 74 75 32 80 63 44 73 75 53 ...
Страница 309: ...JUNE 2002 TOSHIBA TEC 8 1 e STUDIO550 650 810 WIREHARNESSCONNECTIONDIAGRAMS 8 WIRE HARNESS CONNECTION DIAGRAMS ...
Страница 313: ...1 1 KANDA NISHIKI CHO CHIYODA KU TOKYO 101 8442 JAPAN R02032112000 TTEC ...