e-STUDIO550/650/810 ADJUSTMENT
3 - 38
June 2002 © TOSHIBA TEC
3. 10. Adjustment of Exit/Reversal Unit
3. 10. 1. Adjustment of sideways deviation
at reverse discharging
When a paper sideways deviation occurs at
reverse discharging, the transport guide position
is adjusted through the following procedure.
(1) Open the exit side door.
(2) Loosen 6 screws fixing the transport guide.
(3) Remove 2 screws, and take off the plate.
(4) Set the plate lengthwise, and fix it again with
2 screws after adjusting the plate installing
position depending on the paper deviation
amount.
(5) Remove 2 screws, and take off the plate with the latch holder.
(6) Turn the latch holder to the opposite direction, and install it to the plate.
(7) Turn the plate upside down (with the long hole upside), and install it again with 2 screws after
adjusting the same amount as did in the above (4).
Содержание e-studio550
Страница 115: ...JUNE 2002 TOSHIBA TEC 4 11 e STUDIO550 650 810 PREVENTIVE MAINTENANCE Rear side 20 74 75 32 80 63 44 73 75 53 ...
Страница 309: ...JUNE 2002 TOSHIBA TEC 8 1 e STUDIO550 650 810 WIREHARNESSCONNECTIONDIAGRAMS 8 WIRE HARNESS CONNECTION DIAGRAMS ...
Страница 313: ...1 1 KANDA NISHIKI CHO CHIYODA KU TOKYO 101 8442 JAPAN R02032112000 TTEC ...