e-STUDIO550/650/810 TROUBLE SHOOTING
5 - 32
JUNE 2002 © TOSHIBA TEC
[E5A] Trailing edge of paper not passing the exit sensor
Is there any paper at the reverse section when the exit cover is opened?
Remove the paper.
Is the exit motor driving? (Perform the output check in the test mode: 03-120)
1. Check if the connector of the exit motor is not disconnected.
2. Check if the connector J336 on the LGC board is not disconnected.
3. Check if the connector pins are not disconnected and the harness is not
open-circuited.
4. Check if the conductor pattern on the LGC board is not short- or open-
circuited.
5. Replace the LGC board.
1. Check if the setting of the paper size is correct.
2. Check if there is no abnormality and extraneous material at the guide and myler in front of the
exit roller.
3. Check if there is no mechanical loading at the exit follower roller.
NO
YES
YES
NO
Содержание e-studio550
Страница 115: ...JUNE 2002 TOSHIBA TEC 4 11 e STUDIO550 650 810 PREVENTIVE MAINTENANCE Rear side 20 74 75 32 80 63 44 73 75 53 ...
Страница 309: ...JUNE 2002 TOSHIBA TEC 8 1 e STUDIO550 650 810 WIREHARNESSCONNECTIONDIAGRAMS 8 WIRE HARNESS CONNECTION DIAGRAMS ...
Страница 313: ...1 1 KANDA NISHIKI CHO CHIYODA KU TOKYO 101 8442 JAPAN R02032112000 TTEC ...