JUNE 2002 © TOSHIBA TEC
5 - 57
e-STUDIO550/650/810 TROUBLE SHOOTING
[C1C] External LCF tray motor driving abnormally (Feeding is abled from the cassettes other
than the external LCF.)
Is the tray motor driving? (Perform the output check in the test mode: 03-271)
1. Check if the connector J815 on the LCF tray motor is not disconnected.
2. Check if the connectors J801~804 on the LCF board are not disconnected.
3. Check if the connector of the tray-up sensor is not disconnected.
4. Check if the actuator reaches the sensor.
5. Check if the power (24V) is supplied to 1pin and 2pin of J803. If not, check if
the door switch is turned ON and the harness of it is not open-circuited.
6. Replace the LCF board.
7. Replace the LGC board.
Is the tray-up sensor working? (Perform the input check in the test mode: 03-[ENERGY SAVER]
OFF/[1]/[C]
1. Check if the connector of the tray-up sensor is not disconnected.
2. Check if the connectors J801~804 on the LCF board are not disconnected.
3. Check if the actuator reaches the sensor.
4. Check if the coppector pins are not disconnected and the harness is not
open-circuited.
5. Replace the LCF board.
6. Replace the LGC board.
1. Check if the tray lifting mechanism has no abnormality.
2. Replace the LCF board.
3. Replace the LGC board.
YES
NO
YES
NO
Содержание e-studio550
Страница 115: ...JUNE 2002 TOSHIBA TEC 4 11 e STUDIO550 650 810 PREVENTIVE MAINTENANCE Rear side 20 74 75 32 80 63 44 73 75 53 ...
Страница 309: ...JUNE 2002 TOSHIBA TEC 8 1 e STUDIO550 650 810 WIREHARNESSCONNECTIONDIAGRAMS 8 WIRE HARNESS CONNECTION DIAGRAMS ...
Страница 313: ...1 1 KANDA NISHIKI CHO CHIYODA KU TOKYO 101 8442 JAPAN R02032112000 TTEC ...