JUNE 2002 © TOSHIBA TEC
5 - 39
e-STUDIO550/650/810 TROUBLE SHOOTING
[EA3] Paper remaining inside the finisher at power ON
Is there any paper remaining on the transport path in the finisher?
YES
Remove the paper.
NO
Is any of the connectors J17, J24 and J11 on the finisher controller PC board disconnected?
Is the harness connecting the finisher controller PC board and inlet sensor (PI1) open-circuited?
Is the harness connecting the finisher controller PC board and buffer path inlet paper sensor (PI17)
open-circuited?
Is the harness connecting the finisher controller PC board and buffer path paper sensor (PI14) open-
circuited?
Is the harness connecting the finisher controller PC board and delivery sensor (PI3) open-circuited?
YES
Connect the connectors securely. Replace the harnesses.
NO
Is the inlet sensor working properly? (Check the movement of the actuator.)
Is the buffer path inlet paper sensor working properly? (Check the movement of the actuator.)
Is the buffer path paper sensor working properly? (Check the movement of the actuator.)
Is the delivery sensor working properly? (Check the movement of the actuator.)
NO
1. Connect the connectors of the sensors securely.
2. Attach the actuators securely if their shafts are out of place.
3. Replace the sensors.
YES
Replace the finisher controller PC board.
Содержание e-studio550
Страница 115: ...JUNE 2002 TOSHIBA TEC 4 11 e STUDIO550 650 810 PREVENTIVE MAINTENANCE Rear side 20 74 75 32 80 63 44 73 75 53 ...
Страница 309: ...JUNE 2002 TOSHIBA TEC 8 1 e STUDIO550 650 810 WIREHARNESSCONNECTIONDIAGRAMS 8 WIRE HARNESS CONNECTION DIAGRAMS ...
Страница 313: ...1 1 KANDA NISHIKI CHO CHIYODA KU TOKYO 101 8442 JAPAN R02032112000 TTEC ...