JUNE 2002 © TOSHIBA TEC
5 - 3
e-STUDIO550/650/810 TROUBLE SHOOTING
[E09] Jam caused by an abnormal HDD
(1) Check if the connectors of the HDD are disconnected.
(2) Check if the connector pins are disconnected and the harnesses are open-circuited.
(3) Replace the HDD.
(4) Replace the SYS board.
[E20] Paper fed from the 1st cassette not reaching the registration sensor
Open the jam access cover. Is there any paper in front of the registration sensor?
YES
Remove the paper.
NO
Is the registration sensor working?
(Perform the input check in the test mode: 03-[ENERGY SAVER]ON/[4]/[E])
NO
1. Check if the connector of the registration sensor is disconnected.
2. Check if the connector J341 on the LGC board is disconnected.
3. Check if the connector pins are disconnected and the harnesses are open-circuited.
4. Check if the conductor pattern on the LGC board is short- or open-circuited.
5. Replace the registration sensor.
6. Replace the LGC board.
YES
Is the 1st cassette feed clutch working?
(Perform the output check in the test mode: 03-201)
NO
1. Check if the connector of the 1st cassette feed clutch is disconnected.
2. Check if the connector J329 on the LGC board is disconnected.
3. Check if the connector pins are disconnected and the harnesses are open-circuited.
4. Check if the conductor pattern on the LGC board for short- or open-circuited.
5. Replace the upper cassette feed clutch.
6. Replace the LGC board.
YES
Check the 1st cassette feed roller and separation roller. Replace them if they are worn out.
Содержание e-studio550
Страница 115: ...JUNE 2002 TOSHIBA TEC 4 11 e STUDIO550 650 810 PREVENTIVE MAINTENANCE Rear side 20 74 75 32 80 63 44 73 75 53 ...
Страница 309: ...JUNE 2002 TOSHIBA TEC 8 1 e STUDIO550 650 810 WIREHARNESSCONNECTIONDIAGRAMS 8 WIRE HARNESS CONNECTION DIAGRAMS ...
Страница 313: ...1 1 KANDA NISHIKI CHO CHIYODA KU TOKYO 101 8442 JAPAN R02032112000 TTEC ...