e-STUDIO550/650/810 TROUBLE SHOOTING
5 - 6
JUNE 2002 © TOSHIBA TEC
Is the external LCF transport clutch working? (Perform the output check in the test mode: 03-273)
1. Check if the connector of the external LCF feed clutch is not disconnected.
2. Check if the connectors J801~804 on the LCF board are not disconnected.
3. Check if the connector J346 on the LGC board is not disconnected.
4. Check if the connector pins are not disconnected and the harness is not
open-circuited.
5. Check if the conductor pattern on the LCF and LGC boards is not short- or
open-circuited.
6. Replace the external LCF feed clutch.
7. Replace the LCF board.
8. Replace the LGC board.
1. Check if there is any abnormality at the transport drive unit.
2. Check the condition of the external LCF feed roller and separation roller and clean them, or if
they are deteriorated, replace them.
YES
NO
Содержание e-studio550
Страница 115: ...JUNE 2002 TOSHIBA TEC 4 11 e STUDIO550 650 810 PREVENTIVE MAINTENANCE Rear side 20 74 75 32 80 63 44 73 75 53 ...
Страница 309: ...JUNE 2002 TOSHIBA TEC 8 1 e STUDIO550 650 810 WIREHARNESSCONNECTIONDIAGRAMS 8 WIRE HARNESS CONNECTION DIAGRAMS ...
Страница 313: ...1 1 KANDA NISHIKI CHO CHIYODA KU TOKYO 101 8442 JAPAN R02032112000 TTEC ...