Tokyo Keiki KRG-10, Руководство пользователя

Страница: 95 / 200

6-20
(1) Reading basic settings data
To read the basic settings data from the device, click the "Read" button. After reading starts,
wait momentarily until the processing progress on the status bar stops.
(2) Writing basic settings data
To write the basic settings data to the device, input the data to write and then click the "Write"
button. After writing starts, wait momentarily until the processing progress on the status bar
stops.
Basic Settings data
- LCD Indication Content displayed on the LCD
(Level / distance / volume / flow / output current / signal amplitude /
electronic temperature / maximum volume / maximum flow /
volume ratio / flow ratio / elapsed time from start / search count /
elapsed time from final search / margin of sensitivity)
- Measurement Unit Measurement units
(m/Ft) *The distance unit in a sentence is indicated as
a case of “m” setup.
- Display Offset Offset of level / distance displayed on the LCD
(-99999.0m to 99999.0m)
- Antenna Type Antenna type
●
High Power (use only)
(2” cone / 4” cone / 2”PTFE Sealing / 4” PTFE Sealing
1” rod / 2” pipe / 4” pipe)
- Bore Internal diameter of the pipe (valid only when 2” pipe /
4” pipe is selected)
(0.0m to 99999.0m)
- G Distance from reference point to gauging reference point
(-99.999m to 99.999m)
- R Distance from gauging reference point to zero level
(0.0m to 99.999m)
- C Distance from zero level to bottom of tank
(0.0m to 99.999m)
- H Dead zone
(0.0m to 99.999m)
Fig. 6.3.2 Antenna type
Cone
PTFE Sealing Rod Pipe