Thermo 15i, Инструкция по эксплуатации

Страница: 235 / 288

C-Link Protocol Commands
Datalogging
Thermo Fisher Scientific Model 15 i Instruction Manual B-17
diag volt iob
This command reports the diagnostic voltage measurements on the I/O
expansion board. The sequence of voltages is: Positive 24, positive 5,
positive 3.3, and negative 3.3. Each voltage value is separated by a space.
Send: diag volt iob
Receive: diag volt iob 24.10 4.90 3.20 -3.20
clr records
This command will clear all lrecs and srecs that have been saved.
Send: clr records
Receive: clr records ok
set clr lrecs
set clr srecs
These commands will clear only the lrecs or only the srecs that have been
saved. The following example clears srecs.
Send: set clr srecs
Receive: set clr srecs ok
data treatment lrec
data treatment srec
These commands report the current selection of data treatment for
concentrations in the lrecs or srecs. The following example reports the data
treatment for concentrations in lrec as minimum.
Send: data treatment lrec
Receive: data treatment lrec min
set data treatment lrec string
set data treatment srec string
string = | cur | avg | min | max |
These commands set the data treatment to current, average, minimum, or
maximum for the concentration values recorded in the lrecs or srecs. The
following example sets the data treatment for concentrations in lrec as
minimum.
Send: set data treatment lrec min
Receive: set data treatment lrec min ok
Datalogging