Teledyne T200, Руководство по эксплуатации, Страница: 236 / 425

Troubleshooting & Service Teledyne API
– T200 NO/NO2/NOx Analyzer Operation Manual
234
Concentration display
continuously cycles
through all gasses
SAMPLE RANGE=500.0 PPB NOX= XXXX
<TST TST> CAL SETUP
SETUP X.X SECONDARY SETUP MENU
COMM VARS DIAG EXIT
EXAMPLE
DIAG I/O 0) EXT_ZERO_CAL=OFF
PREV NEXT EDIT PRNT EXIT
Use the PREV and
NEXT keys to cycle
through the VARS.
DIAG I/O 1)EXT_SPAN_CAL=OFF
PREV NEXT JUMP EDIT PRNT EXIT
Use the JUMP key to go
directly to a specific
signal.
(see Appendix A for a list
of all I/O SIGNALS)
DIAG I/O JUMPTO: 0
0 0 JUMP ENTR EXIT
Toggle these keys
to set No. of the
VAR to JUMP to.
DIAG I/O JUMPTO: 29
2 9 JUMP ENTR EXIT
DIAG I/O 29) AUTO_ZERO_VALVE=OFF
PREV NEXT JUMP OFF PRNT EXIT
Pressing the PRNT key will send a
formatted printout to the serial port
and can be captured with a computer
or other output device.
SETUP X.X ENTER PASSWORD:818
8 1 8 ENTR EXIT
DIAG SIGNAL I/O
NEXT ENTR EXIT
On status signals this
key toggles the signal
ON / OFF.
SETUP X.X PRIMARY SETUP MENU
CFG DAS RNGE PASS CLK MORE EXIT
Figure 12-1: Example of Signal I/O Function
Note
Any I/O signals changed while in the signal I/O menu will remain in effect ONLY
until signal I/O menu is exited. The Analyzer regains control of these signals
upon exit.
See Appendix A for a complete list of the parameters available for review under
this menu.
06858E DCN7057