Teledyne T200, Руководство по эксплуатации, Страница: 213 / 425

Teledyne API
– T200 NO/NO
2
/NO
X
Analyzer Operation Manual Instrument Maintenance
211
11.3.2. CHANGING THE O
3
DRYER PARTICULATE FILTER
The air for the O
3
generator passes through a dryer equipped with a small particulate
filter at its inlet, which prevents dust from entering the ozone dryer and degrading the
dryer‟s performance over time. Change the filter according to the service interval in
Table 11-1 as follows:
1. Before starting the procedure, check and record the average
RCEL
pressure and
the
OZONE FLOW
values.
2. Turn off the analyzer, unplug the power cord and remove the cover.
3. Unscrew the nut around the port of the filter using two 5/8” wrenches.
ATTENTION
COULD DAMAGE INSTRUMENT AND VOID WARRANTY
Ensure to use proper wrenches.
Hold the main dryer fitting with a 5/8‖ wrench to ensure that it does not turn
against the dryer.
Performing this procedure improperly or with incorrect tools creates a risk of
causing a significant leak.
4. Take off the old filter element and replace it with a suitable equivalent (Teledyne
API P/N FL-3).
Figure 11-2: Particle Filter on O
3
Supply Air Dryer
5. Hold the main dryer fitting steady with a 5/8” wrench and tighten the nut with your
hands.

If necessary use a second wrench but do not over-tighten the nut.
6. Replace the cover, plug in the power cord and restart the analyzer.
06858E DCN7057