Tally XPRESS T9412i, Руководство пользователя

Страница: 32 / 115

26 Chapter 4, The Operator Panel
O
PERATOR
P
ANEL
L
IGHTS
The four lights, or LEDs, on the Operator Panel have the
following functionality.
note:
Both the Operator Panel and the on-screen Status
Monitor, available in some circumstances, can show
printer status. For more information about the Status
Monitor see page 103.
*Factory default settings can be found on the printer’s
Configuration Sheet
Buttons Function
Factory Default Reset
During power-up, press and hold the Go/
Continue and Cancel buttons simultaneously.
• Press and hold the buttons approximately 4
seconds until all lights blink three times and
cycle once, then release the buttons. The
printer will revert to its factory default
settings.*
Factory Default NIC Reset
After performing the Factory Default Reset
above, press and hold the
Go/Continue and
Cancel Job buttons simultaneously to reset the
NIC (network interface card) to its default
settings.
• You must continue holding down the
buttons for
20 seconds, all four LEDs will
once again blink three times and then cycle
one more time. At this point the printer will
execute a NIC Factory Default Reset.
Internal Cleaning Sheet
To enable the internal cleaning process, press
and hold the
Go/Continue and Cancel buttons
simultaneously for about 4 seconds or until all
four lights are blinking.
An Internal Cleaning Sheet will print.
LED Function
The Error LED (red light) indicates various error
conditions affecting the printer.
The Manual Feed LED (amber light) indicates a
manual feed job in the Multipurpose Tray.
The Paper LED (amber light) indicates the paper
tray supply.
The Ready LED (green light) indicates whether
the printer is online, offline, or in Energy Saving
mode.