Subaru 2006 Legacy, Руководство пользователя

Страница: 880 / 4302

SC(H4SO)-24
Generator
STARTING/CHARGING SYSTEMS
(3) Disconnect the connection and remove the
brush.
10) Remove the rectifier as follows.
(1) Remove the bolts which secure the rectifier.
(2) Remove the cover on terminal B.
(3) Remove the nuts of terminal B, then remove
the rectifier.
D: ASSEMBLY
Assemble in the reverse order of disassembly.
1) Pull-out of the brush
Before assembling, press the brush down into the
brush holder, then fix the brush in that position by
inserting a [1 mm (0.08 in) dia., 40 to 50 mm (1.6 to
2.0 in) long] wire through the hole as shown in the
figure.
CAUTION:
After re-assembling, remove the wire.
2) Install the ball bearings.
(1) Set the ball bearings in the front cover, then
securely install an appropriate tool (such as a
socket wrench of proper size) to the bearing
outer race.
(2) Using a press to press the ball bearings into
the specified location.
(3) Install the bearing retainer.
3) Use a press to install the bearings (rear side) to
the rotor shaft.
4) Heat the bearing box in rear cover [50 to 60°C
(122 to 140°F)], and then press the rear bearing
into rear cover.
CAUTION:
Do not apply grease to the rear bearings. If
there is any oil on the bearing box, remove it
completely.
5) After re-assembling, manually turn the pulley to
check that the rotor rotates smoothly.
SC-00088
SC-00089
SC-00090
SC-00091
(A) Wire
SC-00092
(A)
asieps_tobira.book 24 ページ ２００９年１０月２６日 月曜日 午前９時１６分