Subaru 2006 Legacy, Руководство пользователя

Страница: 3233 / 4302

4AT-50
Front Vehicle Speed Sensor
AUTOMATIC TRANSMISSION
14.Front Vehicle Speed Sensor
A: REMOVAL
1) Set the vehicle on a lift.
2) Disconnect the ground cable from the battery.
3) Remove the air intake chamber.
<Ref. to IN(H4SO)-7, REMOVAL, Air Intake Cham-
ber.>
4) Disconnect the transmission connector.
5) Remove the pitching stopper. <Ref. to 4AT-42,
REMOVAL, Transmission Mounting System.>
6) Remove the transmission connector from stay.
7) Lift-up the vehicle.
8) Clean the transmission exterior.
9) Remove the ATF drain plug to drain ATF.
CAUTION:
After running the engine or after idling for a
long time, the ATF is hot. Be careful not to burn
yourself.
10) Tighten the ATF drain plug.
NOTE:
Use a new gasket.
Tightening torque:
25 N·m (2.5 kgf-m, 18 ft-lb)
11) Remove the front, center and rear exhaust
pipes and muffler. <Ref. to EX(H4SO)-4, REMOV-
AL, Front Exhaust Pipe.> <Ref. to EX(H4SO)-8,
REMOVAL, Rear Exhaust Pipe.> <Ref. to
EX(H4SO)-10, REMOVAL, Muffler.>
12) Remove the shield cover.
13) Remove the propeller shaft. <Ref. to DS-10,
REMOVAL, Propeller Shaft.>
14) Place the transmission jack under the transmis-
sion.
NOTE:
Make sure that the support plate of transmission
jack does not touch the cross.
15) Remove the transmission rear crossmember
bolt.
16) Lower the transmission jack.
NOTE:
Do not separate the transmission jack and trans-
mission.
17) Remove the oil cooler inlet and outlet pipes.
NOTE:
When removing the outlet pipe, be careful not to
lose the ball and spring used with retaining screw.
18) Remove the front vehicle speed sensor and
torque converter turbine speed sensor.
(A) Transmission connector
(A) Oil pan
(B) ATF drain plug
AT-01337
(A)
AT-01332
(B)
(A)
(A) Front vehicle speed sensor
(B) Torque converter turbine speed sensor
AT-00043
AT-00044
( A )
( B )
asieps_tobira.book 50 ページ ２００９年１０月２６日 月曜日 午前９時１６分