Subaru 2006 Legacy, Руководство пользователя

Страница: 3253 / 4302

4AT-104
AT Main Case
AUTOMATIC TRANSMISSION
B: INSTALLATION
1) Install the low & reverse brake piston.
NOTE:
• Take care not to damage the lip seal.
• Apply ATF to the lip.
2) Install the return spring.
3) Install the spring retainer.
4) Install the one-way clutch inner race, spring re-
tainer and return spring.
5) Tighten the socket head bolts evenly from the
rear side of transmission case.
Tightening torque:
25 N·m (2.5 kgf-m, 18 ft-lb)
6) Place the front side of transmission body up.
7) Install the thrust needle bearing.
8) Place the dish plate, driven plate, drive plate and
retaining plate neatly in this order on surface table.
9) Set the micro gauge to retaining plate, and read
its scale.
NOTE:
The value, which is read in the gauge at this time, is
zero point.
10) Scale and record the weight “Z” of a flat board
which will be put on retaining plate.
NOTE:
• Use a stiff board which does not bend against
load as a flat board to be put on retaining plate.
• Use a flat board of its weight less than 82 N (8.5
kgf, 18.7 lb).
11) Put the flat board on retaining plate.
12) Using the following formula, read the push/pull
gauge, and calculate “N”.
N = 83 N (8.5 kgf, 18.7 lb) – Z
N: Value indicated on push/pull gauge
83 N (8.5 kgf, 18.7 lb) : Load applied to clutch plate
Z: Flat board weight
AT-00300
AT-00301
AT-00302
AT-00296
AT-01720
asieps_tobira.book 104 ページ ２００９年１０月２６日 月曜日 午前９時１６分