Subaru 2006 Legacy, Руководство пользователя

Страница: 3331 / 4302

5AT-7 8
Converter Case
AUTOMATIC TRANSMISSION
32.Converter Case
A: REMOVAL
1) Remove the transmission assembly from vehicle
body. <Ref. to 5AT-34, REMOVAL, Automatic
Transmission Assembly.>
2) Remove the torque converter assembly. <Ref. to
5AT-63, REMOVAL, Torque Converter Assembly.>
3) Remove the transmission harness connector
from stay.
4) Remove the turbine speed sensor 1. <Ref. to
5AT-52, REMOVAL, Turbine Speed Sensor 1.>
5) Remove the oil charge pipe. <Ref. to 5AT-62,
REMOVAL, Oil Charge Pipe.>
6) Remove the ATF filter inlet and outlet pipes.
<Ref. to 5AT-55, REMOVAL, ATF Filter.>
7) Remove the converter case attachment bolts.
8) Lay along the transmission body, and then re-
move the oil pan.
9) Remove the three converter case mounting bolts
(TORX
®
).
ST 18676AA020 TORX
®
WRENCH
10) Separate the converter case by lightly tapping
with plastic hammer.
11) Remove the differential assembly. <Ref. to
5AT-89, REMOVAL, Front Differential Assembly.>
12) Remove the oil seal from converter case.
B: INSTALLATION
1) Check the appearance of each component and
clean them.
2) Press-fit the oil seal to converter case using ST.
ST 499587100 OIL SEAL INSTALLER
3) Install the differential assembly to the case.
<Ref. to 5AT-89, INSTALLATION, Front Differen-
tial Assembly.>
4) Install the right and left side retainers. <Ref. to
5AT-92, ADJUSTMENT, Front Differential Assem-
bly.>
5) Apply proper amount of liquid gasket to the en-
tire matching surface of converter case.
Liquid gasket:
THREE BOND 1215 (Part No. 004403007)
6) Install the converter case assembly without
damaging bushing and oil seal.
Tightening torque:
41 N·m (4.2 kgf-m, 30.4 ft-lb)
7) Install the three converter case mounting bolts
(TORX
®
).
ST 18676AA020 TORX
®
WRENCH
Tightening torque:
41 N·m (4.2 kgf-m, 30.4 ft-lb)
AT-01974
AT-01979
ST
AT-01975
AT-01974
asieps_tobira.book 78 ページ ２００９年１０月２６日 月曜日 午前９時１６分